Network Analyzers : Agilent-Keysight E8364C

Este producto es Reconstrudio

Agilent E8364C
Ampliar imagen de Agilent E8364C

Llame al 1-800-615-8378 para más información

Request a Quote

Keysight E8364C PNA Series Microwave Network Analyzer, 10 MHz to 50 GHz


The Keysight E8364C PNA Microwave Network Analyzer provides general purpose network analysis with optional software. Key Specifications:
* 104 dB of dynamic range and <0.006 dB trace noise
* <26 usec/point measurement speed, 32 channels, 20,001 points
* TRM/LRM calibration for the most accurate on-wafer, in-fixture, waveguide and antenna measurements
* Mixer conversion loss, return loss, isolation, and absolute group delay
* Amplifier gain compression, harmonic, IMD, and pulsed-RF

Options at additional cost:
  • 010 - Add time domain capability
  • 014 - Configurable test set deck
  • 016 - Add receiver attenuators
  • 080 - Frequency offset
  • 081 - Reference-receiver switch
  • 082 - Scalar calibrated converter measurements
  • 083 - Frequency converter measurement application
  • 084 - Embedded LO measurements
  • 1A7 - 1SO 17025 compliant calibration
  • 1CM - Rack mount kit for installation without handles
  • 1CP - Rack mount kit for installation with handles
  • 301 - Application for use with standard CalPods
  • 302 - Application for use with temperature-characterized CalPods
  • 550 - Add 4-port measurement application
  • 551 - Adds N-port calibrated measurements
  • 711 - Standard power range
  • 897 - Built-in performance test software for Agilent inclusive calibration, perpetual license
  • 898 - Built-in performance test software for standards compliant calibration, perpetual license
  • A6J - ANSI Z540 compliant calibration
  • H11 - IF access (for antenna and pulsed-RF measurements). Requires 014, 080,081,and UNL)
  • UK6 - Commercial calibration certificate with test data
  • UNL - Extended power range with bias tee
  • Fabricantes: Agilent-Keysight
  • Modelo: E8364C

 *
 *

 *


*








Please Enter the following Verification Number and then click Send