Pattern Generators : Agilent-Keysight 81110A

Este producto es Reconstrudio

Agilent 81110A
Ampliar imagen de Agilent 81110A

Llame al 1-800-615-8378 para más información

Request a Quote

Elija entre más de 250 fabricantes y más de 27000 productos


The Keysight 81110A with one or two Keysight 81111A output modules is a single/dual-channel 165 MHz Pulse Pattern Generator.
In comparison to the Agilent 81104A, the 81110A offers the same performance on a wider frequency range. Delay and pulse width and repetition rate in non-PLL mode are more accurate (3% or 0.5% with self-calibration).

Alternatively, the Keysight 81110A with one or two Keysight 81112A output modules is a single/dual-channel 330 MHz Pulse Pattern Generator. Instead of variable transitions, 800 ps or 1.6 ns edges are selectable. The output impedance is 50 Ohm and provides up to 3.8 Vpp into 50 Ohm. Internal channel addition is not available.

Note: Each Keysight 81110A 165 MHz single-/dual-channel Pulse Pattern Generator requires one/two of the output channels Agilent 81111A (165 MHz, 10 V, 50 Ohm into 50 Ohm).

Specifications
  • Single-/dual-channel pulse pattern generator
  • 165 MHz, 10 V, 50 Ohms into 50 Ohms (81111A) OR
  • 330 MHz, 3.8 V, 50 Ohms into 50 Ohms (81112A)
  • Triggerable / PLL operation selectable
  • Pulse / burst / pattern modes selectable
  • Self-cal for improved timing accuracy
  • BNC outputs: single-ended (81111A) // differential (81112A)

Options:

1CM - Rackmount kit
1CN - Handle kit
1CP - Rackmount and handle kit
1CR - Rack slide kit
NOC - No Output Channel
UFJ - 1 MB SRAM memory card
UK6 - Commercial cal. certificate w/ test data
UN2 - Rear Panel Connectors
1CN018A - Handle Kit 88.1mm H (2U) - Two Front Handles
1CP011A - Rackmount Flange and Handle Kit 88.1mm H (2U) - Two Brackets and Front Handles
81111A-FG - 10V 165 MHZ Output Channel for 81110A
81112A-FG - 3.8V 330 MHz Output Channel for 81110A
  • Fabricantes: Agilent-Keysight
  • Modelo: 81110A

 *
 *

 *


*








Please Enter the following Verification Number and then click Send